Century S244 Spezifikationen PDF herunterladen (Seite 6)

1.3 CLEARANCES

Clearances to any combustibles when measured directly from the floor protector to the ceiling must

be a minimum of 84" (2134 mm). Clearances to any combustibles when measured directly from the

front of the stove must be a minimum of 48" (1219 mm). The stove must also be placed so as to

maintain the minimum clearances to combustible walls specified for each type of connector used.

See Table 1.3 below for all clearance measures. Refer to Figure 1.3 for a diagram of each of the

measures A through C.

Clearances to combustible materials

MODELS

BACK (A)

Single wall pipe / Double wall

SIDES (B)

Single wall pipe / Double wall

CORNERS (C)

Single wall pipe / Double wall

HEIGHT (D)*

S244 15.5" (395mm) / 15.5" (395mm) 18" (455mm) / 18" (455mm) 10" (255mm) / 10" (255mm) 84" (2.13m)

FW2470 17" (430mm) / 5.5" (140mm) 10.5" (265mm) / 2.5 (65mm) 10.5" (265mm) / 2.5 (65mm) 84" (2.13m)

FW2700 15.5" (395mm) / 15.5" (395mm) 17.5" (420mm) / 17.5" (420mm) 11" (280mm) / 11" (280mm)

84" (2.13m)

FW3000

15" (380mm) / 15" (380mm) 26" (660mm) / 26" (660mm) 12" (305mm) / 12" (305mm)

84" (2.13m)

*Height, from floor protection to ceiling

You ma

decrease these clearances b

installin

heat radiation shields between the walls or the

ceilin

and the stove. These heat radiation shields must be installed permanentl

, and can

include sheet metal, a rigid non-combustible sheet or a masonr

wall. The installation standards

of such heat radiation shields are listed on the following page.

IT IS STRICTLY FORBIDDEN TO PLACE WOOD WITHIN MINIMUM CLEARANCES

TABLE 1.3 Clearances to combustible materials

For mobile home installation

• Outside air kit with a listed double wall connector(CAN: ULC S641; USA: UL103) and

listed compatible chimney system(CAN: ULC S629; USA: UL103HT)

• Use clearances from combustibles specified in the double wall connector installation.

CAUTION: The structural integrity of the mobile home floor, wall and ceiling/roof

must be maintained.

...............................................

FIGURE 1.3 Clearances to combustible materials

1 2 3 4 5 6 7 8 9 10 11 ... 46 47

Kommentare zu diesen Handbüchern

Keine Kommentare

Century S244 Spezifikationen Seite 6

Kommentare zu diesen Handbüchern